Yorkville PA Package 4x YXL 10 with Crown XLi 3500 Power Amp & 100′ Cables

Description YXL10 YXL 10-inch / 1-inch – 300 Watts – Passive CabinetThe YXL cabinets use a single driver and 90 x 40 degree horn with 1-inch throat and 1-inch compression driver. Constructed from strong Polypropylene, YXL is poised to uphold Yorkville’s reputation for reliability and durability. The cabinets can be positioned upright or used as a monitor wedge. Features300 Watts (Program)8 Ohms10-inch woofer with 2-inch voice coil1-inch compression driver90° x 40° HF dispersionPolypropylene cabinet constructionSpecificationsSystem Type Passive LoudspeakerActive or Passive PassivePower Rating (Watts) 300 Watts ProgramSensitivity (dB @1Watt/1m) 97dBMax SPL (dB) 122dB ContinuousFrequency Response (Hz /- 3dB) 55 – 16k (Hz /-3dB)Dispersion (°H x °V) 90 x 40Crossover Frequency (Hz) 1.6kHzHF Horn Integrated into BaffleLF Driver(s) 10-inch (2-inch voice coil)Feet RubberBar Handles 1 x Side / 1 x BackFlying Hardware 2 (Top)Optional Flying Hardware YesEnclosure Materials Polypropylene, Metal grilleBaffle Material PolypropyleneGrille Powder Coated Steel with Grille ClothOther Details Rubber feet on bottom and side with the monitor WedgeDimensions (DWH xbackW, inches) 11 x 13.25 x 20.5Dimensions (DWH xbackW, cm) 28 x 33.5 x 52Weight (lbs/kg) 29.9 / 13.6Specifications subject to change without notice   With over six decades of experience designing and building rock-solid products, Crown is the standard in amplifier technology. So check out the affordable Crown XLI Series. They are a powerful argument for quality and value! Power Matrix Recommended for: Portable PA. FeaturesStereo/parallel/bridge-mono modeUser selectable input sensitivity – 0.775V and 1.4VEfficient forced-air cooling prevents excessive thermal buildupElectronically balanced RCA & XLR inputs; binding post and Speakon outputsTwo level controls, power switch, power LED, and six LEDs which indicate signal presence, clip and fault for each channelProtection against shorts, no-load, on/off thumps and radio-frequency interference SpecificationsFrequency Response 20 Hz – 20 kHz, 0/-1 dB (at 1 watt)THD <0.5%, 20 Hz – 20 kHzIntermodulation Distortion =/ <0.35% (60 Hz and 7 kHz at 4:1 from full rated ouput to -30 dB)Slew Rate >10V/usVoltage Gain 36 dBDamping Factor (8 ohms, 10 Hz to 400 Hz) >200Signal To Noise Ratio (A-weighted) >100 dBCrosstalk (below rated power) 20 Hz to 1 kHz -75 dB, -59 dBInput Sensitivity (for full rated power at 8 ohms) 0.775V or 1.4VInput Impedance (nominal balanced, unbalanced) 20kΩ, 10kΩAC Line Voltage and Frequency Configurations Available ( 10%) 120V~60 Hz; 220V~50/60 Hz; 230-240V~50/60 HzDimensions 19″ x 3.5″ x 14.4″ (48.3cm x 8.9cm x 36.6cm)Weight 43lbs (19.5kg)IEC Power Connector 15A